Instructions on how to maintain forklift batteries

Ways to maintain batteries for electric forklifts

Forklift battery maintenance is an extremely important part of keeping forklift operations in warehouses, yards, and docks running smoothly. When a forklift lifts goods up and down with high intensity without care, maintenance or maintenance, it often causes your forklifts to quickly break down and your ability to work is gradually lost. capacity. But instead, if you take the time to care for this type of forklift, and with a few simple steps on how to care for your forklift, you can get the most out of your battery’s lifespan for years to come.

Proper care and watering of the battery can help prolong the life of this industrial battery. Here are 7 simple tips for proper forklift battery maintenance:

Keep the battery clean, dry and free of corrosion.
Maintain the correct water level (about a half inch below the battery cap).
Add water after the battery charge cycle.
Establish a weekly or monthly watering (flush/ flush/ add) watering plan to ensure proper battery water level.
Avoid overcharging the battery (charge during breaks and lunch breaks) because every time you connect the battery to the charger, one of its reduced life cycles is added.
Inspect your battery for/early detect any defects or failures and have them repaired by your service provider if necessary.
Have your forklift batteries cleaned and serviced every six months to control acid and corrosion.
Here are 10 essential factors users need to know to take care of forklift batteries:

– Add approved water – never add acid

– Keep the electrolyte level above the separator

– Keep the battery clean and dry

– Keep fire and metal away from the top of the battery

– Keep the vent cap in place, avoid clogging the vent cap.

– Up to 80% off and no battery operation if specific gravity is less than 1,150 for Powerline, Varta batteries, No water and 1,175 power source for Energy-Plus batteries

– Cool before charging or operating if the battery is above 115 degrees Fahrenheit

– Use only approved chargers with the correct voltage and output.

– Keep the forklift compartment and battery cover open while charging

– When in any doubt, call your service representative for assistance

Instructions for filling the battery water:

– Approved water: Only distilled and deionized water should be added to the battery, check your specifications.

– Proper electrolyte level: The dielectric level must be kept between the “high water level” and the separation guard. Only refill the battery at the end of the charge cycle.

Attention: Do not overfill. Moisture on the top of the battery means the battery is overcharged.